Shree Bissa Engineering

This contamination can be tested quickly and simply using the Bresle Test Kit. This kit has advantage over portable units. Test can be quickly performed at site, shop floor and plants. The Bresle Patch is attached to the surface; the distilled water is injected with a syringe then extracted, repeat ten cycles of injecting and extracting then measure with the Conductivity meter.

Compact conductivity meter will measure the quantity of salts in ??g/cm2 (ppm) and mg/m2. Bresle test complies with ISO 8502-6, which relates to the extraction of soluble contaminants and ISO 8502-9, which relates to the conduct metric determination of soluble salts.

Calibration Certificates traceable are available for the Conductivity Meter in the kit.

The Bresle Test Kit is supplied with 50 Bresle Patches, 1 Conductivity Meter, Calibration Solutions, 5x5ml Syringes, 25ml Beaker and 250ml Distilled Water. Additional Bresle Patches can be purchased to carry out further tests using this kit.

• High Accuracy: Reliable readings for precise coating thickness measurements
• Dual Measurement Modes: Suitable for ferrous and non-ferrous substrates
• User-Friendly Interface: Easy operation with a digital display
• Portable and Compact: Lightweight design for convenient use on-site
• Data Storage Options: Some models support data saving and reporting

• Automotive and aerospace surface coating inspection
• Industrial paint thickness evaluation
• Pipeline and tank coating quality assurance
• Surface protection in marine industries

Press O Film Gauge Known as Dial thickness Gauge, we having both types of model: Digital Dial thickness gauge & Analog Dial thickness Gauge.

A precision instrument designed to measure surface roughness profile (anchor pattern depth) after sand blasting or shot blasting operations.

Surface profile measurement is critical before coating, painting, or applying protective systems to ensure proper adhesion and long-term performance.

A Digital Surface Profile Gauge is an advanced electronic instrument used to measure:

• Surface roughness depth (µm / mils)

• Anchor pattern height

• Blast-cleaned steel profile

• Peak-to-valley height

It provides instant digital readings, eliminating manual calculation errors and ensuring accurate inspection results.

Pull-off adhesion tester is a device used to measure the adhesion strength of a coating to a substrate. It typically consists of a calibrated spring-loaded mechanism or hydraulic system that applies a controlled force to a specific test area of the coating. The force required to pull the coating away from the substrate is measured, providing a quantitative assessment of adhesion strength.

These testers are commonly used in industries such as automotive, aerospace, construction, and manufacturing, where the quality and durability of coatings are crucial. They help ensure that coatings adhere properly to substrates, which is essential for preventing issues such as corrosion, delamination, and premature coating failure.

A Pin Hole Detector is an essential inspection instrument used to identify pinholes, porosity, and microscopic coating defects in protective paint layers, linings, and corrosion-resistant coatings.

This sponge type pin hole detector is specially designed for testing thin to medium film thickness coatings applied on pipelines, tanks, structural steel, marine components, and industrial equipment.

Supplied with a high-quality conductive sponge brush, the detector ensures accurate fault location without damaging the coating surface—making it ideal for quality control and surface protection inspections.

Key Features of Pin Hole Detector

• Detects pinholes and porosity in protective coatings

• Supplied with durable conductive sponge brush

• Lightweight and easy to operate

• Audible & visual alarm on defect detection

• Safe for thin coating inspection

• Battery operated portable design

• Rugged housing for site use

• Fast scanning over large surfaces

• Pipeline coating inspection

• Storage tanks & vessels

• Structural steel coatings

• Marine & offshore structures

• Water pipelines & linings

• Epoxy, PU & bituminous coatings

• Powder coating inspection

• Corrosion protection projects